Use precautions of Laminating Machine

1. The power switch box must be a power switch box with a ground wire to ensure safe use of electricity;

2, the film coating workshop is best clean room to ensure the film coating effect;

3. The dust on the equipment and the rubber roller must be completely removed before the film is coated;

4. When the laminating machine is running, it is forbidden to put your fingers into the two rollers to avoid getting the hands; the temperature of the press roller of the machine is high, don't touch it with your hands to prevent burns;

5. Do not disassemble the door panel of the chassis while the machine is running, so as to avoid electric shock or injury to the gear;

6. When performing maintenance or maintenance inspection, it must be ensured that the main power supply is cut off and no maintenance or repair is required.【 Water Based Lamination Machine 】The electrical system of the machine should be well insulated to prevent moisture. When using the machine, the power should be cut off to prevent accidents.

7. Disassemble the heating pipe during maintenance or repair, please handle it with care, so as not to damage the heating pipe;

8. During inspection or maintenance, it is found that the oil flowing out under the bearing should be wiped out to prevent oil from flowing into other parts to affect the normal operation of the machine;

9. Do not operate more than one person when debugging the equipment. The operator must ensure that no one touches the moving parts;

10. Every time you turn on the machine, wipe off the surface dust of each roller, and check whether the surface of each roller of the machine is clean. If the machine malfunctions or abnormally sounds, you should analyze the cause and give it a rule.【Laminating Machine Supplier 】The standby device can continue to use after everything is normal. machine;

11. When the machine is scrubbed, it should be turned on at a low speed. It should be scrubbed in the correct position to prevent the cloth in the hands of the two rollers from being rolled.

12. It is strictly forbidden to place any tools, devices and sundries on the machine;

13. The machine used for new installation should be strengthened to lubricate the machine. Do not use the machine quickly during the running-in period of the machine drive.