Laminator Operating Procedures

1. The sensing element of the temperature controller uses the thermocouple to detect the temperature. Due to the influence of the installation location and the surrounding air temperature and external airflow, the accuracy of the temperature measurement has a large error, which is indicated on the thermometer. The temperature is relative temperature, and the temperature should be selected according to the actual processing experience and the indicated value of the reference thermometer;

2. The site must be supervised when the machine is warmed up;

3. It is necessary to check whether the electrical facilities are in good condition before starting the machine;

4. The safety accessories such as protective covers and plates in the machine must be inspected 【 Film Lamination Machine 】before starting the machine to ensure that they are in good condition and are not allowed to be dismantled at will;

5. When the machine is running, it is forbidden to penetrate the fingers into the two rollers to avoid the hand. The temperature of the press roller of the machine is high. Do not touch the hand to prevent burns. When scrubbing the machine, start it at low speed. It should be scrubbed in the correct position to prevent two rolls. Inside the belt, the cloth in the hand;

6. When replacing the filter screen and adjusting the die and scraping the die, the gloves must be worn. If it is working, it is forbidden to wear gloves.

7. It is strictly forbidden to play bare-chested, shorts, skirts, dresses, etc., must wear tight clothes to work;

8. If there are plastic leakage materials, paper scraps, etc. above the composite roller, 【 Automatic Laminator 】 it should not be removed directly by hand, and should be drawn by means of plastic rods, small wooden sticks, etc.;

9. When cleaning the wrap film on the composite roll, it must be stopped;

10. When unloading, be sure to unload the air pressure system, separate the pressing roller from the rubber roller in time, and loosen the scraper and the pre-pressing roller to prevent the two rollers from being damaged by long-term deformation;

11. When the machine is repaired and inspected, the main power switch of the machine should be turned off. The electrical system of the machine should be well insulated to prevent moisture. When the machine is stopped, the power should be cut off to prevent accidents.

12. It is strictly forbidden to place any tools, devices and sundries on the machine. The working air gap of the rubberizing roller and the rubberizing roller is very small. When any hard object is pressed into the surface of the rubber roller, 【 Lamination Machine Manufacturer 】it will leave a crater on the rubber. Depression or crack. Lighter requires a longer period of natural elastic recovery, and the heavy one directly scraps the rubber roller;

13. Pay attention to electrical leakage and injury. Every employee should be aware of the method of urgently cutting off the main power supply. It is not clear that they are not allowed to work;

14. The machine used for new installation should be strengthened to lubricate the machine. Do not use the machine quickly during the running-in period of the machine drive.