Problems probably occurred during lamination process

Blistering

1. The printed ink layer is not dry. It should be hot pressed and then glued; delay the filming time and make it dry thoroughly.
2. The printed ink layer is too thick. The amount of adhesive applied should be increased to increase the pressure and compound temperature.
3. The drying temperature is too high and the surface of the adhesive is crusted. Should reduce the drying temperature
4. The surface temperature of the composite roll is too high. The composite roll temperature should be lowered.
5. The film has wrinkles or slack, and the film is uneven or curled. [ Lamination Machine Manufacturer ] The film should be replaced and the tension adjusted.
6. There are dust impurities on the surface of the film. It should be cleared in time.
7. The adhesive coating is uneven and the dosage is small. The amount of coating and uniformity should be increased.
8. The binder concentration is too high, the viscosity is large, and the coating is uneven. Apply a diluent to reduce the binder concentration.


Wrinkles

1. The film transfer roller is unbalanced. The transfer stick should be adjusted.
2. The ends of the film are inconsistent or wavy. [ Film Lamination Machine ] The qualified film should be replaced.
3. The glue layer is too thick, the solvent evaporation is not thorough, affecting the viscosity, squeezed by the pressure roller, and slippage between the paper and the film. The amount of glue should be adjusted to increase the temperature of the drying tunnel.
4. The electric heating roller and the rubber roller are unbalanced at both ends, the pressure is inconsistent, and the line speed is not equal. The two rollers should be adjusted.